6.10.5 Emergency evacuation in the event of a malfunction
In the event of other (serious) faults where the lift cannot be lowered in “safety mode” (slow,
downward operation), only a service technician will be able to make the lift move by means of
a special “service mode” to which the user does not have access. It is not possible to lower the
lift manually, but the user can be helped off of the lift manually in such an event by virtue of the
low lift height (max. 1200 mm). If a user needs to be lifted off of the lift (e.g., a wheelchair user)
suitable lifting equipment/aids should be used.
The vertical barrier or door at the upper level can be opened to allow access to the lifting
platform (see description above). Lift installations that are not under constant supervision can
be equipped with an alarm.
7. Function description
The lift is a so-called “Hold to run” lift, i.e., the push buttons must be pushed in throughout the
entire operation.
The lift is easy to operate: The user summons the lift using one of the buttons on the wall/the
call station column, or the accompanying remote control (optional equipment).
When the user is on the platform, it is operated from the panel on the side, from where transport
to the upper or lower level is selected.
8. Assembly
The lift installation is undertaken by an authorized service technician. Do not attempt to move,
disassemble, or repair your lift. These actions MUST be performed by an authorized service
technician.
Improper assembly may increase the risk of user injury. Liftup is exempt from any liability if
assembly and installation are not performed by an authorized service technician.
For more information or materials on assembly, you may contact your dealer, cf.
https://www.liftup.dk/en/distributors/.
To Next Page
