liftup EasyLift V3 PLUS - Page 30

USER MANUAL – EASYLIFT V3 PLUS – AU VERSION 09.02
Liftup A/S Hagensvej 21 | DK-9530 Støvring | Danmark | T: +45 96 86 30 20 | M: support@liftup.dk | www.liftup.dk | CVR: DK-1015 3964
30
How to replace the battery:
Hand-held remote control
1. Loosen the screw (Torx TX 6) on the rear
of the remote control
2. Remove the rear panel
3. Replace the battery
4. Replace the rear panel and test the
remote control
Call station
In order to gain access to the battery, loosen
the 2 Torx screws and pull down the top
cover to separate it from the body.
Call station column
To gain access to the battery, loosen the 4
screws and pull up the top cover carefully.
IMPORTANT!
Be careful not to disconnect the wires from
each other. Pull the printed circuit out of the
top cover carefully.
1. Replace the battery
2. Put the unit together in the reverse order
and test the buttons.
If the remote control or receiver has been without power for a long period of time, it may be
necessary to calibrate the system (pair the two units), see section 13.