Lightspeed Tango - Powering On;Off and Auto Shutoff; Multiple Headsets Configuration

12
Using Your Tango Headset
Turning the system ON and OFF
ON: Press the power button on panel interface
once. The GREENpowerLEDasheswhenpoweris
supplied. Lightspeed Link will automatically connect
to the headset when the system is powered on.
Press the power button on the headset once. The
GREENpowerLEDasheswhenpowerissupplied.
ActiveNoiseReduction(ANR)isengagedwhenyou
turn on the headset.
OFF: Press and hold the power button on the
headset until the GREENpowerLEDturnso.Press
and hold the power button on the panel interface
until the GREENpowerLEDturnso.
Auto Shutoff™
Under quiet conditions Tango will automatically shut
off approximately five minutes after the headset is
removed from your head. The panel interface will
shut off five minutes after it has been unplugged
from the intercom or intercom power is turned
off. Auto Shutoff can be disabled on either device
by holding the power switch for that device for 3
seconds when turning the system on. The power
LEDwilldoubleblinktoindicatethatAutoShuto
has been disabled.
Note:Thepanel-poweredversion(LEMO)ofthe
panel interface runs solely on aircraft power and
turns off immediately when aircraft power is turned
off or when it is disconnected from the aircraft.