Lightspeed Tango - Bluetooth Operation and Features

17
Bluetooth mode—ON and OFF
ON: With Tango turned ON, press and hold the
Bluetooth button until you hear a tone and the
BluetoothindicatorLEDashesthreeBLUE pulses.
For first time pairing see instructions on page 16.
OFF: Press and hold Tango’s Bluetooth button for
about three seconds until a high tone is emitted and
theBluetoothindicatorLEDashesthreeRED pulses.
Note: The Bluetooth feature must be turned ON for
Bluetooth connected devices to correctly function.
When you turn on the Tango Bluetooth mode, it will
connect to the most recently paired device. Most
Bluetooth devices connect to Tango automatically. If
that doesn’t happen it may be necessary to use the
device’s menu of found devices to manually connect
toLightspeed-V###(numbersmayvary).
Bluetooth cell phone features
DependingontheBluetoothproleofthephone,
you can use Tango’s Bluetooth button to perform
several functions. Some typical functions are:
• PressandholdtheBluetoothbuttonfortwo
seconds to redial the last number called.
• PresstheBluetoothbuttononceforvoicedialing
(if supported by your phone).
• PresstheBluetoothbuttononcetoanswerthe
phone when it rings.
• PresstheBluetoothbuttononcetodisconnect
from a call.
BluetoothDevices