Lightspeed Tango - Pairing Your Bluetooth Device

16
Connecting Bluetooth devices for the first time
Before using a Bluetooth cell phone or other
Bluetooth-capabledeviceforthersttimewith
Tango it must be “paired” or electronically connected.
To pair a Bluetooth cell phone with Tango:
1. Turn on the panel interface and verify the
GREENLEDisashing.MakesureBluetooth
mode is turned off. BLUE or RED flashes from
theBluetoothLEDshouldnotbepresent.See
“Bluetooth Mode—ON and OFF” on page 17.
2. Press and hold the panel interface Bluetooth
button for about five to ten seconds or until the
BluetoothLEDcontinuallyashesRED and BLUE.
This lasts about two minutes. If this step takes
longerandtheBluetoothLEDisnolonger
alternating RED and BLUE, start over from step one.
3. With Tango in pairing mode, follow the menu
prompts on your Bluetooth device directing it to
look for Bluetooth devices.
4. SelectLightspeed-V###(numbersmayvary)
on your Bluetooth device from the list of found
devices.
5. If asked to enter a password or PIN, enter 0000.
Your Bluetooth device should now be paired and
ready for use with Tango.
BluetoothDevices