Lightware UCX-2x1-HC30 - Change the Gateway Address (Static); Apply Network Settings; Change the Subnet Mask (Static); Ethernet Port Configuration

 UCX series – User's Manual 125


Set the DHCP State
ATTENTION!  applySettings method

applySettings
Command and Response #dhcp #network #ipaddress
ç <dhcp_status>
æ pw·/V1<dhcp_status>
Parameters
If the <dhcp_status> parameter is true, the current IP address setting is DHCP, if the parameter is false the
current IP address is static.
Example
ç 
æ 
ç 
æ 
INFO:  The applySettings method will save and apply the new value and results the device to reboot.
INFO:  The current setting can be queried by using the GET command.
Change the IP Address (Static)
Command and Response
ç <IP_address>
æ pw·/V1<IP_address>
Example
ç 
æ 
ç 
æ 
INFO:  The applySettings method will save and apply the new value and results the device to reboot.
INFO:  The current setting can be queried by using the GET command.
Change the Subnet Mask (Static)
Command and Response #ipaddress
ç <netmask>
æ pw·/V1<netmask>
Example
ç 
æ 
ç 
æ 
INFO:  The applySettings method will save and apply the new value and results the device to reboot.
INFO:  The current setting can be queried by using the GET command.
Change the Gateway Address (Static)
Command and Response
ç <gw_address>
æ pw·/V1<gw_address>
Example
ç 
æ 
ç 
æ 
INFO:  The applySettings method will save and apply the new value and results the extender to reboot.
INFO:  The current setting can be queried by using the GET command.
Apply Network Settings
Command and Response
ç 
æ 
Example
ç 
æ 
All network settings which are changed have been applied and network interface restarts.



