Lightware UCX-2x1-HC30 - Setting the Hostname; Change the Gateway Address (Static); Apply Network Settings; Change the Subnet Mask (Static)

 UCX series – User's Manual 93

Change the Subnet Mask (Static)
Request and Response #ipaddress
ɯ  <ip>
ɯ body: <netmask>
ɮ header: 200 OK
ɮ body: <netmask>
Example
ɯ  

ɯ body: 255.255.255.0
ɮ header: 200 OK
ɮ body: 255.255.255.0
ɯ  
ɮ header: 200 OK
ɮ body: OK
INFO:  The applySettings method will save and apply the new value and results the device to reboot.
INFO:  The current setting can be queried by using the GET command.
Change the Gateway Address (Static)
Request and Response
ɯ  <ip>
ɯ body: <gw_address>
ɮ header: 200 OK
ɮ body: <gw_address>
Example
ɯ  
ɯ body: 192.168.0.1
ɮ header: 200 OK
ɮ body: 192.168.0.1
ɯ  
ɮ header: 200 OK
ɮ body: OK
INFO:  The applySettings method will save and apply the new value and results the extender to reboot.
INFO:  The current setting can be queried by using the GET command.
Apply Network Settings
Request and Response
ɯ  <ip>
INFO:  
ɮ header: 200 OK
ɮ body: OK
Example
ɯ  
ɮ header: 200 OK
ɮ body: OK
All network settings which are changed have been applied and network interface restarts.
Setting the Hostname
The host name is a property that can be used instead of the IP address when connecting to the device. It is
Add New Favorite
Device section. Furthermore, it can be used to open the The Built-in Miniweb. If the IP address of the device


Request and Response
ɯ  <ip>
ɯ body: <unique_name>
ɮ header: 200 OK
ɮ body: <unique_name>
Parameters
The <unique_name> can be 1-64 character long and the following are allowed for naming: the elements of
the English alphabet and numbers. Hyphen (-) and dot (.) is also accepted except as last character.
Example
ɯ  
ɯ body: room-switcher
ɮ header: 200 OK
ɮ body: room-switcher



