Page 277 of 295
1
Position
2
Steer top in
3
Lock handle
Mounting battery:
1) With open handle (1) - position battery base over the guide track and lower it in place
2) Steer in upper part of battery
3) Press down handle to lock battery in place
Recommendations
• Do not exceed the storage temperature as it will shorten the product life and performance.
• Allow the battery to settle to room temperature before use or charging.
• Only use correct LINAK charger (CHL40 or integrated charger in the CAL40 or CAL40+ control box).
• Do not exceed the duty cycle as it will shorten the product life, reduce performance and eventually activate excess temperature protection.
• BAL40 is intended for use in indoor applications, however not in indoor pool environments.
• If the battery is completely discharged, then recharge the battery before storage.
• Always use correct LINAK charger.).
Warning
DO NOT:
- heat, burn or short-circuit the batteries
- expose the batteries to high impact
- drop, crush or puncture the batteries
- use batteries with signs of damage or corrosion
- charge or store the batteries near combustible material
- charge the batteries without supervision
- overcharge or fully discharge the batteries
- exceed IP ratings
Any of the above mentioned can cause fire or injury.
Check at regular intervals that the ventilation hole is undamaged and intact.
The construction of the ventilation hole permits battery gasses to get out,
but it does not permit penetration of water.
To Next Page
Loading...
Need help?
General
