14
• After having activated the RF handset keys; the reset key must be released.
• If no RF handset keys are activated during the matching procedure; no changes
are made in the ID memory of the TD3.
Start-up - How to install the RF handset:
HB12
HB22
Please be aware that if you use the TD3 for the fi rst time or it has been
disconnected from the mains, the receiver integrated in the TD3 needs approx.
20 sec. before being able to receive a signal.
The TD3 can accept commands from up to 2 RF handsets.
From the factory the TD3 cannot recognise any RF handsets at all and must be
matched to the RF handset(s) by the end-user/bed manufacturer before these can
control the TD3 operation.
Conditions which must be fulfi lled prior to activating the learning mode:
• Both the back and the leg actuators must be in the fully down position;
if one or both actuators are NOT in the fully down position; the matching
procedure cannot be continued as now an ordinary reset down function is
performed instead. Thereafter, the reset key must be released and reactivated.
Activating the learning mode:
• Activate the reset key on the TD3 by using a pen or similar to keep the button
pressed.
• Keeping the reset key activated; the RF handset(s) must be activated one at a
time by pressing a random key on the RF handset. The RF handset ID’s are stored
in the TD3 memory and at the same time, previous RF handset ID’s are erased.
To Next Page
Loading...
Need help?
General
