16
Mains inlet
Battery drawer
Battery cable/connection
Reset
(HB connection)
Ch.1
Ch.2
Ch.3
Connections
CH1 CH2
Footrest Headrest
CH1 CH2 CH3
Headrest
--
-
Headrest
-
--
Headrest
Footrest Headrest
-
Footrest
-
Headrest
-
Footrest Headrest
Footrest Extra function Headrest
Connection of massage motors:
Connection of LA27 actuators:
The TD3 will as default detect and run the LA27 using plug and play rules as
illustrated in the table below. The idea is that the Headrest is the fi rst actuator, the
Footrest second and then Extra function. The Headrest is always the one nearest to
the Backend and the Footrest is always the one nearest to the Leg-end.
Start up/initialisation of LA27:
After connection of the LA27, the system has to be initialised. Push down the
buttom for the LA27, which has to be initialised. When the sound from the LA27
stops the system is initialised. If more than 1 actuator is connected, the same has to
be done with the other channels.
If 2 or 3 x LA27 actuators are connected to the TD3 and one of the LA27 actuators
gets disconnected the function of the HB will change according to above scheme.
To Next Page
Loading...
Need help?
General
