Operation 4
Special equipment
e3861325
1 2 3
4 5 6
7 8 9
*
0 #
12
3
4
¾ Press any key to start input device.
Green LED (2) flashes.
¾ Enter personal PIN number (facto
ry setting
=
0 0 0 0 0
) and state code.
I.e. the following PIN number if vehicle is OK :
0 0 0 0 0 0
appears on the display.
NOTE
If an incorrect input is made, the PIN number
can be corrected by pressing key
*
(4) .
¾ Confirm input using key
#
(3).
Green LED (2) lights up continuously.
NOTE
If the red LED (1) lights up, an inc
orrect PIN
number has been input. Press
*
(4) a
nd re-
peat input . If more than three inc
orrect inputs
are made (factory setting), the r
ed LED (1)
lights up and the green LED (2) fla
shes. The
input of a valid PIN is blocked f
or 10 minutes.
Theblockingtimecanbeinterr
upted by enter-
ing a special PIN number. Pleas
e contact your
fleet manager.
¾ Turn the rotary button (in place of key
switch) clockwise as far as it will go and
start the vehicle.
NOTE
If the vehicle does not start properly the first
time, the start procedure can be repeated until
the rotary button is returned to the zero posi-
tion and the PIN number is no longer stored
after expiry of the delay time.
NOTE
If the green (2) and red (1) LED both light
up continuously, the data must be read out.
Please inform your fleet manager at once.
Switch off vehicle and log off:
¾ Turn the rotary button (5) anticlockwise as
far as it will go.
The engine is turned off.
Operating Instructions – 386 807 1001 EN – 03/2006 61
To Next Page
Loading...
