4 Operation
Standard equipment
NOTE
Before fitting an attachment the hydraulic
system for the additional hydraulics must be
depressurised in order to open the union nuts
on the fork carriage .
¾ Move down the switch lock of the relevant
switch.
¾ Operate the switch for single additional hy-
draulics (couplings on fork carriage right)
and the switch for double additional hy-
draulics (couplings on fork carriage left) .
¾ Unscrew the union nuts on the fork
carriage.
¾ Screw on lines for attachment or connect
plug-in couplings.
NOTE
When the additional hydraulics are operated, it
is necessary to wait a few seconds before they
can be depressurised again via the switches.
Otherwise an error will occur, and operation
of the lift mast will no longer function . In this
case switch off and on again at switch.
CAUTION
Attachments affect the load capacity and stability of
the forklift truck.
Attachments which are not supplied with the forklift
truck should only be used when it has been che-
cked by the authorised dealer that safe operation is
ensured by the allocation in terms of load capacity
and stability .
48 Operating Instructions – 386 807 1001 EN – 03/2006
To Next Page
Loading...
