Operation 4
Special equipment
¾ Turn the rotary button (in place of key
switch) clockwise as far as it will go and
start the vehicle.
NOTE
If the vehicle does not start prop
erly the first
time, the start procedure can b
e repeated un-
til the rotary button (in place
of key switch) is
returned to the zero position a
nd the PIN num-
ber is no longer stored after ex
piry of the delay
time.
NOTE
If the green (2) and red (1) LED both light
up continuously, the data must be read out.
Please inform your fleet manager at once.
Switch off vehicle and log off:
¾ Turn the rotary button (in place of key
switch) anticlockwise as far as it will go.
Vehicle is switched off.
NOTE
After a delay time (factory setting = 10 sec-
onds) the red LED (1) lights up briefly, and
the green (2) and red (1) LED then flash for
approx. 3 seconds. During this period the ve-
hicle can be started at any time. The LEDs are
then extinguished, and the PIN number is no
longer stored. The delay time can be set to
between 10 seconds and 10 minutes via the
diagnostic device. Please contact your autho-
rised dealer.
Pressing the Hash key
#
(3)afterswitchingoff
the motor will immediately interrupt the delay
time and delete the PIN number .
Operating Instructions – 386 807 1001 EN – 03/2006 63
To Next Page
Loading...
