D9U001ES2-0101_02
37
The stretcher includes rmware that can be updated only by an authorised service technician.
This rmware is protected against unauthorised access by mechanical housing (tool is needed to access), by seal (com-
ponents with processor are sealed), by exclusive compatibility with an authorised software tool and by check of compati-
bility of the new rmware with the stretcher.
9.5 Firmware (only Sprint 200 with i-Drive Power)
Attachment plug is means of connecting and disconnecting Sprint 200 with i-Drive Power from the mains.
Power Supply Cord should be safely wound around the Accessory Rail or DIN Rail or safely placed in the Storage Box
when it is not connected to the mains.
10 Power Supply Cord (only Sprint 200 with i-Drive Power)
WARNING!
Where the integrity of the external protective conductor in the installation or its arrangement is in doubt
► Use the other power source that is not in doubt.
WARNING!
Inappropriate handling of the power supply cord, e. g. by kinking, shearing or other mechanical damages is
hazardous!
WARNING!
When routing Power Supply Cord in a Sprint 200 with i-Drive Power avoid squeezing the cable between parts
of the Sprint 200 with i-Drive Power!
WARNING!
An additional multiple socket-outlet or extension cord shall not be connected to the Sprint 200 with i-Drive
Power!
WARNING!
Use exclusively the power supply cord in perfect condition!
► Ensure the power supply cord are not damaged before each use!
WARNING!
Power Supply Cord must not be tightened or stretched during use!
► Ensure the Power Supply Cord hangs loosely between the Sprint 200 with i-Drive Power and the wall where
the Power Supply Cord is connected to the mains.
To Next Page
Loading...
Need help?
General
