LINET Sprint 200

D9U001ES2-0101_0240
To connect Sprint 200 with i-Drive Power to the mains power:
► Unwind the whole Power Supply Cord from the Accessory Rail or DIN Rail at head end of the Sprint 200 with i-Drive Po-
wer.
► Connect the attachment plug of the Power Supply Cord to the mains power.
To place Power Supply Cord to safety position:
► Wind the Power Supply Cord loosely around the Accessory Rail or DIN Rail at head end of the Sprint 200 with i-Drive
Power as on the picture above.
To disconnect Power Supply Cord from the Sprint 200 with i-Drive Power:
► Disconnect the Power Supply Cord from the mains.