EasyManuals Logo

Linhai B-Type 200 User Manual

Linhai B-Type 200
362 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #251 background imageLoading...
Page #251 background image
CHAPTER 5 FINAL DRIVE ATV SERVICE MANUAL 09.0
CHAPTER 5 FINAL DRIVE. 5-
4
bearing for moisture, dirt, or corrosion, or
roughness is evident.
5.3 a. FRONT HUB ASSEMBLY (ATV150/200/260/300)
1. Drive or press one new bearing in
to hub using a bearing driver (2WD).
2. Drive or press the other bearing into hub until
seated against the hub shoulder (2WD).
3. Coat the new bearing with grease (2WD).
4. Coat the spline with grease (4WD)
5. Install new seal into hub (with numbers facing
out) until flush with end of seal bore. Do not
damage the surface of the seal. Coat the
lip with special grease.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Linhai B-Type 200 and is the answer not in the manual?

Linhai B-Type 200 Specifications

General IconGeneral
BrandLinhai
ModelB-Type 200
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals