CHAPTER 3A ENGINE 260/ 300 / 400 cc ATV SERVICE MANUAL09.0
CHAPTER 3 ENGINE PAGE. 3A- 16
1. Start the engine and let it warm up for several
minutes.
2. Turn off the engine and inspect the coolant
level again.
NOTE:
Wait a few minutes until the coolant settles
before inspecting the coolant level.
COOLANTRE PLACE MENT
1. Remove:
zFront cover of ATV plastic body work.
zSeat.
2. Remove:
zHose c (reservoir tank)
Drain the reservoir tank of its coolant.
3. Remove:
zDrain bolt c
zRadiator cap
WARNING:
Do not remove the radiator cap when the
engine and radiator are hot. Scalding hot
fluid and steam may be blown out under
pressure, which could cause serious injury.
When the engine has cooled, open the
radiator cap as follows:
Place a thick rag or a towel over the radiator
cap. Slowly rotate the cap counterclockwise
toward the detent. This allows any residual
pressure to escape. When the hissing sound
has stopped, press down on the cap while
turning counterclockwise and remove it.
NOTE:
zRemove the radiator cap after removing the
drain bolt.
To Next Page
Loading...
Need help?
General
