Linhai M565Li - Page 85

M565Li OWNER’S/OPERATOR’S MANUAL
16. MAINTENCE
85
Rear Differential Gear Lubrication (E4 models)
Be sure no foreign material enters the gear case.
With the ATV on a level surface, remove fill plug and visually inspect the oil
level through the fill hole. Oil should be kept even with the center of the drill
point approximately below the top of the fill hole.
NOTE: Do not add oil to the bottom of the fill plug threads.
Correct Rear Differential case oil: SAE GL-5 85W/90.
Recommended Rear Differential oil:
MAXIMA HYPOID GEAR LUBE PREMIUM 80W90 - GL5
Oil Change
1.
Remove the drain plug. Catch and discard used oil properly.
2.
Clean and reinstall the drain plug with a new sealing washer and tighten
securely 22~30 Nm.
3.
Remove the fill plug and add 300 ml of SAE GL-5 85W/90 Gear oil and
inspect oil level. Oil level should be kept even with the center of the drill point
(approximately below the top of the fill hole).
4.
Reinstall the fill plug. Tighten securely to 22~30 Nm.
5.
Check for leaks.
SAE 80W/90 GL-5