EtherFast
®
10/100 LAN Card
Chapter 5: Manual Installation and
Setup for Windows 95
After installing the EtherFast 10/100 LAN card in your computer, follow these
instructions for installing the network device driver. For troubleshooting tips
during setup, refer to the Troubleshooting section.
The installation procedure for the network driver will vary slightly depending
on which version of Windows 95 you are using. To begin the driver installation,
and to determine which version of Windows 95 you are using:
1. If you haven’t already done so, start up your PC.
2. Windows 95 will automatically detect the EtherFast 10/100 LAN Card in
your computer and an Update Device Driver Wizard window (a window
similar to the one below) will appear.
While the Update Device Driver Wizard window is visible, put the Linksys
LNE100TX(ver. 5) Setup Utility CD into your CD-ROM drive and click the
Next button.
Overview
9
Instant EtherFast
®
Series
4b. If you are using Windows
2000, you will see the fol-
lowing screen:
On this screen, you will need to type your computer’s name in the appro-
priate field. Then, click the Driver Install button to continue.
5a. The drivers will now be installed.
If you are using Windows
95, 98, Millennium, or
XP, you will see the fol-
lowing screen.
This signifies that the driver installation is complete and your system will
reboot.
5b. The drivers will now be installed.
If you are using Windows 2000, you will see
the following screen. If requested to reboot, do
so manually at this time.
This signifies that the driver installation is complete. You should now reboot
your system.
Driver installation is complete!
10
To Next Page
Loading...
Need help?
General
