ENGLISH
13AKURATE KONTROL
STOP BITS
Set the stop bits to suit the RS232 protocol being used.
Options:
1, 2
Default setting:
1
RS232 EVENTS
If set to
ENABLED
, the unit passes information regarding its
internal status to an external device that accepts RS232 data.
Options:
ENABLED, DISABLED
Default setting:
DISABLED
Select
SAVE
to save your changes and return to the GENERAL
SETUP menu.
Select
BACK
to return to the GENERAL SETUP menu without
saving changes.
Select
EXIT
to leave setup (if changes have been made and SAVE
has not been selected, you will be prompted to save or not save
the changes).
ANNALOG 6 TYP
E
This item informs you of the setting for the internal phono stage
(connected to the 6/PHONO input). Either
PHONO MM
(moving-
magnet),
PHONO MC
(moving-coil) or
LINE LEVEL
will be displayed.
If the internal phono stage is reconfigured, the shown setting will
update automatically.
Select
SAVE
to save your changes and return to the GENERAL
SETUP menu.
Select
BACK
to return to the GENERAL SETUP menu without saving
changes.
Select
EXIT
to leave setup (if changes have been made and SAVE has
not been selected, you will be prompted to save or not save the
changes).
Linn Disc setup
This menu is for use if you are adding a Linn AKURATE CD player as a
multi-channel source, or a UNIDISK player (see pages 14 to 16).
ANALOG SOURCE
Options:
ANALOG GROUP, ANALOG 1 to 6, NONE
Default setting:
NONE
DIGITAL SOURCE
Options:
SPDIF 1 to 3, TOS (TOSLINK) 1 to
3, NONE
Default setting:
NONE
Select
SAVE
to save your changes and return to the MAIN MENU.
Select
BACK
to return to the MAIN MENU without saving changes.
Select
EXIT
to leave setup (if changes have been made and SAVE has
not been selected, you will be prompted to save or not save the
changes).
Notes:
If an AKURATE CD player is used as the Linn Disc source, the name
for the source as shown on the front panel will be ‘LINN DISC’, not
‘AKURATE CD’.
If a Linn AKURATE CD or UNIDISK player is not connected to the
AKURATE KONTROL using the supplied RS232 lead (see pages 14 to
16), ‘LINN DISC’ will not be seen on the front panel as an available
source.
If the input you wish to use is not shown when you cycle through the
options, it is because that input has already been assigned to a
source. To correct this, enter the Source setup menu, select the back
panel input you require, set Type to
NONE
, then save the change.
When you re-enter the Linn Disc setup menu the new input will be
available.
ENGLISH
To Next Page
Loading...
Need help?
General
