8
Connecting a tape recorder
To make recordings in conjunction with the CLASSIK, connect the
TAPE OUT sockets to the line input of the tape deck and the
monitor sockets to the line output from the tape deck.
The TAPE IN sockets can be used to connect a second tape
recorder for playback only, or another source.
Connecting to loudspeakers
Connect your loudspeakers to the CLASSIK using inverted 4mm
sockets and high-quality speaker cable. Ensure that the speaker
phase is maintained (red to positive, black to negative).
The CLASSIK provides two pairs of speaker connections so you can
connect up to two pairs of speakers. The CLASSIK will drive two
pairs of 8Ω speakers or one pair of 4Ω speakers. However, its
protection will prevent damage if you accidentally overload it.
Using the CLASSIK with an external power amplifier
You can use the CLASSIK with an external power amplifier by
connecting the PRE OUT sockets on the rear panel to the input
sockets on the power amplifier. This allows you to upgrade your
system by using an external power amplifier of even higher
performance, such as the Linn LK100, LK240, or KLOUT.
Connecting headphones
You can connect a pair of headphones to the headphone socket on
the front panel of the CLASSIK. This is fed from a dedicated
headphone amplifier, and when the headphone jack is plugged in
both the speaker and preamplifier outputs are muted
automatically.
To Next Page
Loading...
