13
Switching on and off
To switch on
To switch the CLASSIK on press the power button on the front
panel.
When you first supply power the CLASSIK will be in standby state
and the front panel display shows CD/CA.
This display indicates that the CLASSIK is in standby state, which
uses a negligible amount of power. You can safely leave the
CLASSIK connected and in standby, ready to respond to
commands from the handset or front panel.
However, switch the CLASSIK off if you will not be using it for a
long time.
To switch on from standby
Press any of the following keys on the front panel:
å, >, SRC-, SRC+, VOL-, or VOL+ (see user option 8 for å and >).
Alternatively, press one of the equivalent keys on the handset, or
one of the source selection keys AUX, TP1, TP2, TUN, or CD.
To switch to standby
Press O on the front panel or the handset.
The front panel will show the standby display.
Note: you can choose to have the current time displayed while the
CLASSIK is in standby; see
Customising the CLASSIK
, page 40.
To Next Page
Loading...
