44
Number Name Description Values Explanation
U7 Retain User Retains the last user CD 0 = No Do not retain last CD
CD Settings settings before power off; settings.
ie the last track played, the 1 = Yes Retain last user CD settings
display mode, and CD status saved on power down.
(stopped, paused, or NOTE: The track must
playing). have been playing for at
least 5 seconds for a
correct recovery.
U8 AMP Function If the product is in standby 0 = Disabled The product will not power
and it receives an amplifier up from standby on receipt
source selection, CD PLAY of a source selection or CD
command, or CD OPEN PLAY command.
command, it will power up
1= Enabled The product will power up
and select the appropriate from standby on receipt of a
input. If the CD PLAY source selection, CD PLAY
command is received, it will command, or a CD open
also start the CD playing. If command.
CD OPEN is received then
the product will power up
and the CD drawer will open.
Factory default settings
CLASSIK also supports a Reset to Factory Defaults option which
allows you to reset the unit back to its original settings; see the
default values in the above tables.
To reset the CLASSIK
Switch the product off.
To Next Page
Loading...
