Linn CLASSIK - Page 52

43
Number Name Description Values Explanation
U4 Auto-Listen When the product receives 0 = Disabled The product will not
any CD command (eg PLAY) respond to the CD or tuner
in a non-CD mode (eg tuner function commands unless
selected) it will select the CD the current source is CD or
mode. Similarly, if it receives TUNER.
a tuner command (such as 1= Enabled The product will respond to
PRESET or TUNE) and it is in the CD or tuner function
a non-tuner mode, it will commands even if not
select the external tuner currently selected. The
input. source will be selected and
the requested command
carried out.
U5 Retain User Retains the last user 0 = No Do not retain last settings.
Amplifier amplifier settings before
1 = Yes Retain last amplifier settings
Settings power down/standby. That saved on power down/
is, it remembers the last standby.
source selected, the volume NOTE: If the volume on
setting(s), the balance power down is greater
setting(s), and the record than 30 then the volume
path, etc. on power up will be
limited to 30.
U6 CD Play on Sets the CD engine to start 0 = No Do not start CD playing
Power-up playing automatically on playing immediately on
power up of the unit. power up.
1 = Yes CD starts playing on power
up.