47
you are listening to the CD, the display will always revert back to
showing the current CD status after amplifier commands such as
VOLUME, BALANCE, BASS, TREBLE, and MUTE, etc have been
actioned.
The following is a list of symptoms and cures.
There is no sound from the speakers!
Check that your speakers are connected properly and that the
headphones are not plugged in.
Check that the MUTE indicator is not lit.
Check that your audio source is actually playing and that the
CLASSIK is powered up (not just in STANDBY) and the audio
source is selected.
I cannot change sources!
RECORD LOCK is probably on. Switch RECORD LOCK off by
pressing the RECORD button.
The display shows Err 3 and then shuts down
The amplifier has become too warm and has shut itself down to
cool off. If this happens repeatedly check that there is sufficient
ventilation around the CLASSIK.
I cannot set the clock/clock loses time when the CLASSIK is
switched off
The clock battery is likely to be flat – contact your dealer for a
replacement.
To Next Page
Loading...
