SG1000
™
SMOKE GENERATOR
14
WWW.LIONPROTECTS.COM
4.6 USE WITH WALL POWER BASE
Connect the power supply into a grounded outlet. Turn the power switch on the base
to the “on” position. The light in the switch will turn on. This indicates that power is
being supplied to the Smoke Generator. However, the Smoke Generator will not work
until it is turned on as well.
Turn the Smoke Generator on using the ON/OFF button on the back of the unit. Hold
down the ON/OFF button for approximately three seconds until you hear a click. The
green light above the switch will remain on when you release the button to indicate
that the machine is turned on.
4.7 TURNING THE SMOKE GENERATOR ON AND OFF
Turn the machine on using the ON/OFF BUTTON (Letter A in Figure 11, below) on
the back of the Smoke Generator. Hold down the ON/OFF BUTTON for approximately
three seconds until you hear a click. The green light above the switch will remain on
when you release the button to indicate that the machine is turned on.
If the green light turns off when you release the button, the Smoke Generator is NOT
on. Try turning the machine on again, holding the ON/OFF BUTTON longer.
To turn the SG1000
™
off, press and hold the ON/OFF BUTTON until the LED above
the CONTINUOUS BUTTON starts to blink. Release the ON/OFF BUTTON and the
unit will turn off.
FIGURE 11: SG1000 CORE UNIT
A
B
C
D
E
F
To Next Page
Loading...
Need help?
General
