SG1000
™
SMOKE GENERATOR
24
WWW.LIONPROTECTS.COM
4.25 USING THE SG1000
™
SMOKE GENERATOR WITH A BULLSEYE
™
SYSTEM OR ATTACK
™
SYSTEM
The SG1000 is designed to automatically communicate and work together with
a BullsEye system and/or ATTACK system when in WiFi range. The SG1000
will not automatically work with a BullsEye system with a serial number
beginning with 0705. Older BullsEye system owners will need to manually add
smoke to the evolution.
When the SG1000 and BullsEye system are linked, you can create smoke manually
or automatically.
4.26 HOW TO LINK THE SG1000 SMOKE GENERATOR WITH A
BULLSEYE SYSTEM OR ATTACK SYSTEM
1. Turn on the BullsEye/ATTACK system and the SG1000.
2. After approximately 30–60 seconds, the BullsEye/ATTACK system and SG1000
will automatically communicate with each other.
3. To conrm that they are communicating, the LED on the handle of the SG1000
will slowly blink green. Using the BullsEye/ATTACK system remote, you will be
able to adjust the smoke level or trigger a smoke burst.
4. If the two are not communicating, the LED on the handle of the SG1000 will be
a steady green. If you are using an iPad control, it will display “NO LINK”.
4.27 WHAT TO DO IF THE SG1000 SMOKE GENERATOR WON’T
COMMUNICATE WITH A BULLSEYE SYSTEM OR ATTACK SYSTEM
1. Make sure the SG1000 and BullsEye/ATTACK system are within WiFi range. To
see if this is the problem, bring the SG1000 and BullsEye to the same room
and restart the power on each of them. If the SG1000 links, the equipment was
previously out of range.
2. If the devices don’t automatically communicate when in range, contact your
distributor or LION for assistance.
To Next Page
Loading...
Need help?
General
