15
WWW.LIONPROTECTS.COM
4.8 MAKING SMOKE
The Smoke Generator can make smoke three ways:
• On-Demand using the button on the handle.
• Continuously using the Continuous Mode.
• Using an external controller.
4.9 ON-DEMAND SMOKE PRODUCTION
Press the button on the handle of the Smoke Generator to make smoke.The Smoke
Generator will produce smoke as long as the button is pressed. You may notice that
there is a short delay as the Smoke Generator heats up. The smoke production
may also be inconsistent until it has reached optimal operating temperature.
4.10 CONTINUOUS MODE SMOKE PRODUCTION
Turn on Continuous Mode by pressing the CONTINUOUS button (Letter C in
Figure 11, page 14) for approximately 2 seconds until the light above the button
illuminates. Press the smoke button on the handle to start smoke production.
Press the smoke button again to stop smoke production.
The smoke intensity is adjustable by turning the knob next to the continuous button
(Letter D in Figure 11, page 14). Continuous mode can be turned off by pressing
the button (Letter C in Figure 11, page 14) for approximately two seconds until the
light above the button goes out.
4.11 PRODUCING SMOKE USING AN EXTERNAL CONTROLLER
There are several external controllers that can be used with the Smoke Generator:
• Wireless Remote.
• DMX interface.
• Wired Remote.
• Custom external controller using XLR connectors.