Why does my Lippert Components ground control 3.0 touch panel say 'LOW VOLTAGE'?
If the Lippert Components Lifting Systems touch panel displays 'LOW VOLTAGE', this could be due to a bad connection or wiring, or a discharged or bad battery. Check the wiring for issues and repair or replace as needed. Also, test the battery voltage under load and charge or replace the battery if necessary.
What to do if Lippert Components ground control 3.0 touch panel shows 'AUTO LEVEL FAIL'?
If the Lippert Components Lifting Systems touch panel displays 'AUTO LEVEL FAIL', the controller might be unsecured or there could be a voltage drop. Check and secure the controller placement. Also, test the battery voltage under load and charge or replace the battery if needed.
What does 'EXCESSIVE ANGLE' mean on my Lippert Components ground control 3.0 touch panel?
If the Lippert Components Lifting Systems touch panel displays 'EXCESSIVE ANGLE', it could be due to the controller not being properly secured or an excessive angle reached during manual operation. Check and secure the controller placement. If that doesn't solve the problem, relocate the coach.
What does 'OUT OF STROKE' mean on Lippert Components ground control 3.0 Lifting Systems touch panel?
If the Lippert Components Lifting Systems touch panel displays 'OUT OF STROKE', this can be caused by an unsecured controller or an uneven or sloped site. Check and secure the controller placement, and relocate the trailer.
Why does my Lippert Components Lifting Systems touch panel say 'EXCESS ANGLE'?
If the Lippert Components Lifting Systems touch panel displays 'EXCESS ANGLE', this could be due to an unsecured controller or an uneven or sloped site. Check and secure the controller placement. You may also need to relocate the trailer.
How to fix 'FEATURE DISABLED' message on Lippert Components ground control 3.0 Lifting Systems?
If the Lippert Components Lifting Systems touch panel displays 'FEATURE DISABLED', this may be because hitch recognition was requested but no hitch height has been set or the zero point has not been set. Perform the "AUTO LEVEL" sequence to establish hitch height or set the zero point.
What to do if Lippert Components Lifting Systems shows 'BAD CALIBRATION'?
If the Lippert Components Lifting Systems touch panel displays 'BAD CALIBRATION', it means that the trailer zero point was not set correctly. Reset the zero point to resolve this issue.
Why is the Lippert Components Lifting Systems LED indicator solid red?
If the Lippert Components Lifting Systems Red/Green LED indicator is solid red, it indicates a low battery. Charge or replace the battery.
What does 'JACK TIME OUT' mean on Lippert Components Lifting Systems?
If the Lippert Components Lifting Systems touch panel displays 'JACK TIME OUT', it means the system could not level in the expected time. Check the disposition of the jacks.
Why is the Lippert Components ground control 3.0 LED indicator off?
If the Lippert Components Lifting Systems Red/Green LED indicator is off, it means the touch panel is locked. Unlock the touch panel.
General| Brand | Lippert Components |
|---|---|
| Model | ground control 3.0 |
| Category | Lifting Systems |
| Language | English |
To Next Page
