Lippert Components ground control 3.0 - Page 7

Rev: 05.23.2017 Page 7 Ground Control 3.0 Service Manual
Bottom of Jack Motor Override:
Tools needed:
⁄
” drive ratchet and extension,
⁄
” socket
1. Find the port on the bottom of the jack motor (Fig. 9A).
2. Remove the rubber plug (Fig. 10A).
3. Insert the
⁄
” socket into the port (Fig. 11).
4. Turn override until the jack extends or retracts to desired position.
Fig. 7
A
Fig. 8
Fig. 6
A
Fig. 10
A
Fig. 11
Fig. 9
A