Lippert Components ground control 3.0 - Manual Override; Jack Motor Override Procedures

Rev: 03.02.2017
Page 15
Ground Control 3.0 with OneControl
Manual Override
Top of Jack Motor Override:
Tools needed:
⁄
” drive ratchet and extension (no socket)
1. Find the port on the top of the jack motor (Fig. 12A).
2. Remove the rubber plug (Fig. 13A).
3. Insert the
⁄
” drive ratchet into the port (Fig. 14).
4. Turn the override until the jack extends or retracts to desired position.
Bottom of Jack Motor Override:
Tools needed:
⁄
” drive ratchet and extension,
⁄
” socket
1. Find the port on the bottom of the jack motor (Fig. 12B).
2. Remove the rubber plug (Fig. 15A).
3. Insert the
⁄
” socket into the port (Fig. 16).
4. Turn the override until the jack extends or retracts to desired position.
Fig. 12
Fig. 13
A
Fig. 14
Fig. 15
Fig. 16
A
A
B