System Information
The Solera® Power Awning features an internal motor to steadily operate the awning. Additionally, the pitch
arm assembly allows for rain dump and adjustable pitch features. The pitch arm assembly also provides
added stability. Additional information about this product can be obtained or by downloading the free
myLCIapp. The app is available on iTunes® for iPhone® and iPad® and also on Google Play™ for Android™
users.
iTunes®, iPhone® and iPad® are registered trademarks of Apple Inc.
Google Play™ and Android™ are trademarks of Google Inc.
Resources Required
• Three People
• Cordless or Electric Drill or Screw Gun
• Appropriate Drive Bits
• Rivet Gun (If Needed)
• Screwdriver
• Wire Cutters/Strippers
• Non-Permanent Method of Marking
• Silicone Sealant or Butyl Tape
• Silicone Lubricant
This manual provides operational procedures for Solera Power Awning. Operating the Solera Power
Awning in any other manner than described may result in personal injury, damage to the recreational
vehicle unit or the awning assembly as well as voiding the Lippert Components Limited Warranty.
NOTE: This manual will refer to the “drive side” and “idler side” throughout for various instructions. The
“drive side” is the right hand side of the awning when facing the awning from the exterior of the
unit. The “idler side” is the left hand side of the awning when facing the awning from the exterior of
the unit.
Prior To Installation
NOTE: All screws supporting the awning assembly must have a backer within the structure of the wall of the unit.
Refer to the unit manufacturer for proper location.
To Next Page
Loading...
