Lippert Components Solera Power Awning - AWNING LED LIGHT CONNECTORS; Introduction; If LED Lights Need To Be Replaced

AWNING LED LIGHT CONNECTORS
(LIGHT IN THE ROLL BAR OR LIGHTED FABRIC)
TI-239
AWNINGS
Introduction
In mid to late 2015, the Solera® Awning LED light connectors (for the light in the roll bar or the lighted fabric
applications) were changed as a product improvement. This change was made on a running basis at the
manufacturer's level.
The old style connector was white (Fig. 1). The new style connector is a black (Fig. 2). The two connectors are
not compatible with each other.
Fig. 1 Fig. 2
If LED Lights Need To Be Replaced:
1. If the unit has the black connector (Fig. 2) on the end of the LED lights, only new lights will be needed.
The new lights will come with the black connector that will match the connector on the idler head on
the awning assembly.
2. If the unit has a white connector (Fig. 1) on the LED lights, new lights and a new idler head assembly
will be needed. The new lights will come with the black connector which is not compatible with the
white connector. The new idler head will have the black connector to match the black connector on
the new lights. The connection point is between the idler head and the end of the roll bar (Fig. 3 and
Fig. 4).
Fig. 3 Fig. 4