CONVERSION FROM MANUAL
PULL STRAP TO POWER AWNING
TI-164
AWNINGS
White Kit # Black Kit # Description
323948
323949 Conversion from Manual Pull Strap to Power Awning Kit
NOTE: Parts below are available in kits referenced above or individually as needed.
White Part # Black Part # Description Qty.
266146 273478 Drive Head Assembly 1
266147 273479 Idler Head Assembly 1
273007 Power Feed Wires 1
280570 Wire Harness 1
2661301
2661302 End Cap 2
299630 #8 - 32 X ½" Wax Screws 2
280564 280566 Switch 1
280565 280567 Switch Plate 1
285079 285077 Bezel Spacer 2
275080353 2750701888 Wire Cover ; 22" - Narrow 2
275070157 2750701692 Wire Cover; 9.75" - Narrow 2
266139429 2661391964 Wire Cover; 26.75" - Wide 2
266139337 2661391872 Wire Cover; 21" - Wide 2
266138481 2661382017 Wire Cover; 30" - Narrow 2
Prior To Conversion
Tools Required
• Electric screw gun
• #2 square screwdriver bit
• #3 Phillips bit
• Zip ties
• (2) Cotter pins (.09" x 2 ⁄" OAL Zinc Plated
Hairpin or equivalent)
Resources Required
• Two People
Procedure
1. Extend awning out approximately 1' and
insert cotter pins through both end caps into
the shafts on the head assemblies (Fig. 1).
NOTE: If the awning is 6' in length it will only
need one cotter pin on the drive side.
Fig. 1
To Next Page
Loading...
