As a supplier of components to the RV industry, safety, education and customer satisfaction are our primary concerns.
10. Secure the fabric in the awning rail no more than 1” inside the edge of the fabric on both ends using a #6 x
½
”
hex head screw. Install the screw down through the awning rail into the fabric and the polycord (Fig. 11).
1"
Awning Rail
Fabric Stitching
Fig. 11
AWNING FABRIC REPLACEMENT
TI-166
AWNINGS
11. Reinstall the drip cap (if previously equipped).
12. Reconnect any light wiring as needed.
NOTE: The fabric LED light strip will need to be installed on the polycord of the fabric prior to connecting any
wiring previously removed.
To Next Page
Loading...
