B
A
Fig. 11
NOTE: Be sure the black wire is connected to a ground and the red wire is connected to a 3 amp maximum
fuse (usually behind the switch) and then a power source from the unit.
LED Light Rail Installation
NOTE: Solera Power Awning must be installed prior to LED Light Rail installation.
1. Seal the back of the LED light rail.
2. Mount the LED light rail (Fig. 12B) directly below the awning rail (Fig. 12A) and secure to the side of the
unit.
3. Remove the wire covers in the drive side mount arm.
4. Route the light wire over the top of the upper brackets on the mount arm and run the light wire down
through the support arm assembly in the same manner as the motor wire (Fig. 12C).
Installation with Speakers Option
1. Remove wire covers on both mount arms.
2. At both support arm assemblies there will be a wire
labeled "speakers." Connect these to the radio wires
provided from the unit (Fig. 10).
NOTE: Speaker wire is indicated with blue insulation on
the wiring.
NOTE: On the drive side, the speaker wire will be
connected at the same location on the support
arm assembly as the power wire for the motor. On
the idler side, the speaker wire may be connected
at the top or bottom of the support arm assembly.
Installation with LED Options
LED Roll Tube Installation
1. Remove the wire covers in the idler side mount arm.
2. Be sure to align LED light wires (Fig. 11A) coming
from idler head with the LED light on roll tube
(Fig. 11B).
3. Connect the plug from the idler head (Fig. 11A) to the
plug from the LED light (Fig. 11B) on the roll tube.
4. Take the LED power wire that is already fed through
the idler leg and connect to the desired power wire
from the unit.
Fig. 10
A
B
C
Fig. 12
To Next Page
Loading...
