LiteOn EVO 8000 Series - Page 108

105
Parameter
Name
Description
Setting Range
o2-03
<2>
Drive Capacity
Selection
Set this parameter after replacing the terminal
block or drive modules.
Default: <2>
Determined by
drive capacity
o2-04
ENTER Key Function
During Frequency
Command Setting
0 ∶ ENTER Key Required
1 ∶ ENTER Key Not Required
When entering a frequency command, the
output frequency changes immediately by UP or
DOWN key without pressing ENTER.
Default: 0
Range: 0, 1
o2-05
<7>
Action selection
when the LCM
operator is
disconnected
0 : Invalid
1: Effective
Default: 0
Range: 0, 1
o2-06
Operation Direction
at Power Up when
Using Keypad
0 ∶ Forward
1 ∶ Reverse
This parameter is enabled only when the keypad is
selected as the Run command source.
Default: 0
Range: 0, 1
o3
Retain
o4: Maintenance Settings
o4-00
Cumulative
Operation Time
Setting
Sets the initial value by 10 hours to start keeping
track of cumulative operation time.
Default: 0 h
Min.: 0 h
Max.: 6000 h
o4-02
Cooling Fan
Operation Time
Setting
Sets the initial value to start keeping track of
cumulative fan operation time. View the
cumulative fan operation time in U3-01.
Default: 0 h
Min.: 0 h
Max.: 6000 h
o4-03 ~
o4-05
Retain
o4-06
U2 Reset Setting
Resets the data for U2-□□ (Fault Information) as
these data will not be reset by A1-03 (Reset).
0 ∶ Disabled
1 ∶ Enabled
Default: 0
Range: 0, 1
o4-07
kWh monitoring
initialization
selection
0: Maintain accumulated power value
1: Reset the accumulated power value
Default: 0
Range: 0, 1
o4-09
ISA Pro function
switch
Turn ISA Pro oscilloscope on/off
0 : Close
1 : Open
Default: 0
Range: 0, 1
Group t, Auto-Tuning
t1: IM Motor Auto-Tuning