LiteOn EVO 8000 Series - Page 76

73
Parameter
Name
Description
Setting Range
C1-05 <4>
Deceleration Time 3
(Deceleration Time
1 for Motor 2)
Sets the time that the drive decelerates from the
maximum output to 0Hz.
C1-06 <4>
Acceleration Time 4
(Acceleration Time
2 for Motor 2)
Sets the time that the drive accelerates from 0Hz
to the maximum output.
C1-07 <4>
Deceleration Time 4
(Deceleration Time
2 for Motor 2)
Sets the time that the drive decelerates from the
maximum output to 0Hz.
C1-08
Fast Stop Time
Sets the time to stop the drive faster.
C1-09
Acc./Dec. Time Unit
Selection
Set the units of time for C1-00 to C1-08.
0 ∶ 0.01 s (0.00 to 600.00 s)
1 ∶ 0.1 s (0.00 to 6000.0 s)
Default∶ 1
Min.: 0
Max.: 1
C1-10
Acc./Dec. Time
Switch Frequency
Sets the frequency level. The drive will switch the
acceleration and deceleration time at this level.
Default: 0.0 Hz
Min.: 0.0 Hz
Max.: <5>
C1-11
Jog Acc. Time
Sets the time to accelerate from 0 Hz to Jog
Frequency Command (L1-16).
Default: 10.0 s
Min.: 0.0 s
Max.: 6000.0 s
C1-12
Jog Dec. Time
Sets the time to decelerate from Jog Frequency
Command (L1-16) to 0 Hz.
Default: 10.0 s
Min.: 0.0 s
Max.: 6000.0 s
C2: S-Curve Characteristics
C2-00
S-Curve
Characteristic at
Acc. Start
Sets S-curve times for each acceleration or
deceleration.
Actual Acceleration Time=
Determined Acc. Time+(C2-00+C2-01)/ 2
Actual Deceleration Time=
Determined Dec. Time+(C2-02+C2-03) / 2
Default∶ 0.00 s
Min.: 0.00 s
Max.: 10.00 s
C2-01
S-Curve
Characteristic at
Acc. End
Default∶ 0.00 s
Min.: 0.00 s
Max.: 10.00 s
C2-02
S-Curve
Characteristic at
Dec. Start
Default∶ 0.00 s
Min.: 0.00 s
Max.: 10.00 s
C2-03
S-Curve
Characteristic at
Dec. End
Default∶ 0.00 s
Min.: 0.00 s
Max.: 10.00 s
C3: Torque Compensation
C3-00 <4>
Torque
Compensation Gain
Sets the gain for the motor 1 Torque
compensation
Default: 0.50
Min.:0.00
Max.:2.50