LiteOn EVO 8000 Series - Page 87

84
Parameter
Name
Description
Setting Range
d1-20
Motor 2 Minimum
Output Frequency
Voltage
Default: <1>
Min.: 0.0 V
Max.: 255.0 V <3>
d1-21
Motor 2 Middle
Output Frequency 2
Default: 0.0
Min.: 0.0 Hz
Max.: Defined by d1-13
d1-22
Motor 2 Middle
Output Frequency
Voltage 2
Default: 0.0 V
Min.: 0.0 V
Max.: 255.0 V <3>
d1-23
<9>
V/F separation
mode selection
0 : V/F mode
1 : V/F complete separation mode
2 : V/F semi-separation mode
Default: 0
Min.: 0
Max.: 2
d1-24
<9>
V/F separation
voltage source
selection
0 : set by d1-25
1 : Given by analog analog input (need to match
E3-01 or E3-07 = 20)
Default: 0
Min.: 0
Max.: 1
d1-25
<9>
V/F separation
voltage parameter
setting
Sets V/F separation voltage parameter
Default: Define by
A1-03
Min.: 0 V
Max.: Motor rated
voltage
d1-26
<9>
Voltage acceleration
time for V/F
separation
Sets the voltage acceleration time for V/F
separation
Default: 10.0 s
Min.: 0.1 s
Max.: 1000.0 s
d1-27
<9>
V/F separation
voltage deceleration
time
Sets the voltage deceleration time of V/F
separation
Default: 10.0 s
Min.: 0.1 s
Max.: 1000.0 s
d1-28
<9>
V/F separation stop
mode selection
0 : Frequency/voltage is independently reduced to
0
1 : After the voltage is reduced to 0V, the
frequency is reduced to 0Hz
Default: 0
Min.: 0
Max.: 1
d2: Motor Parameters
d2-00
Motor Rated
Current
Sets the motor rated current. This will be set
automatically during Auto-Tuning.
Default: o2-03, A1-06
Min.: 10% of drive
rated current
Max.: 200% of drive
rated current
d2-01
Motor Rated Slip
Sets the motor rated slip. This will be set
automatically during Auto-Tuning.
Default: o2-03, A1-06
Min.: 0 rpm
Max.: 60000 rpm
d2-02
Motor No-Load
Sets the motor no-load current. This will be set
Default: o2-03, A1-06