LiteOn EVO 8000 Series - Page 90

87
Parameter
Name
Description
Setting Range
is set.
Min.: 0.00 mH
Max.: 600.00 mH
d3-07
PM Motor Induction
Voltage Constant 1
(Ke)
Sets the induced peak voltage per motor phase in
units of 0.1 mV/(rad/s) (electrical angle). Set this
parameter when driving an IPM motor (SSR1 or
SST4 series).
Set 0 to d3-09 before setting.
Default: Determined by
o2-03
Min.: 0.0 mV/(rad/s)
Max.: 2000.0
mV/(rad/s)
d3-08~d3-
09
Retain
d3-10
<7>
Motor rated voltage
(for PM)
Sets the rated voltage of the motor according to
the nameplate value of the PM motor.
Default : 200.0 V
Min.: 0.0
Max.: 255.0 V <3>
d3-11
<7>
Base frequency of
the motor (for PM)
Sets the base frequency of the motor based on
the nameplate value of the PM motor.
Default : 87.5 Hz
Min.: 0.0
Max.: 400.0 HZ
d3-12
<7>
Base speed of the
motor (for PM)
Sets the base speed of the motor based on the
nameplate value of the PM motor.
Default : 1750 rpm
Min.: 0 rpm
Max.: 24000 rpm
d3-13~d3-
15
Retain
Group E, Multi-Function Terminals
E1: Multi-Function Digital Inputs
E1-00
Terminal S1
Function Selection
0 : 2-Wire Sequence Control (Forward/Stop) /
3-Wire Sequence Control (Stop)
1 : 2-Wire Sequence Control (Reverse/Stop) /
3-Wire Sequence Control (Stop)
2 : 3-Wire Sequence
3 : Local/Remote Selection
4 : Command Source 1/2 Selection
5 to 8: Multi-Step Speed Command 1 to 4
9 : Jog Frequency
10 : Up Command
11: Down Command
12: Up 2 Command
13: Down 2 Command
14, 15: FJOG/RJOG Command
16: Acc./Dec. Time Selection 1
17: Acc./Dec. Time Selection 2
18: Acc./Dec. Ramp Hold
Default : 0
Min.: 0
Max.: 0 ~73 / 100 ~173
E1-01
Terminal S2
Function Selection
Default : 1
Min.: 0
Max.: 0 ~73 / 100 ~173
E1-02
Terminal S3
Function Selection
Default : 23
Min.: 0
Max.: 0 ~73 / 100 ~173
E1-03
Terminal S4
Function Selection
Default : 39
Min.: 0
Max.: 0 ~73 / 100 ~173
E1-04
Terminal S5
Function Selection
Default : 5
Min.: 0
Max.: 0 ~73 / 100 ~173
E1-05
Terminal S6
Function Selection
Default : 6
Min.: 0