LIVOLTEK Hyper 5000 - Page 61

61
EPS Volt Fault
Output Voltage abnormal
(Inverter voltage is higher than
260Vac)
Check if the load power is within the EPS
power range and the AC output wires are
connected well.
EPS Over Load
Overload error. The inverter is
overload 110% and time is
up( more than Five time)
Reduce the connected load by switching off
some equipment, and wait for the recover.
Restart the inverter and contact your dealer
for technical support if the error happens
again.
EPS Short Fault
EPS output short circuit
Check the wires connection. Restart and
contact your dealer for technical support if the
error happens again.
Inter CKT Fault
BUS Voltage (AC) is too high.
Wait for inverter recovery. Contact your
dealer for technical support if the error
happens again.
Inter CKT Fault
Over Current fault.
Inter CKT Fault
Component failure.
Inter Temp High
The ambient temperature inside
the inverter exceeds the upper
limit.
Check the air flow of the unit, then close it
and wait for 30mins.
Contact your dealer for technical support if
the error happens again.
BAT Temp High
Battery (Lead-Acid) temperature
is not within permissible range.
Check the environment temperature. Contact
your dealer for technical support if the error
happens again.
BAT Volt Fault
Battery voltage is not within
permissible range.
Check the spec and quantity of battery and the
connection.
Contact your dealer for technical support if
the error happens again.
BMS Lost
BMS Communication lost.
Check battery type and communication of the
BMS cable. Restart the inverter and contact
your dealer for technical support if the error
happens again.
Low battery
The battery voltage is too low.
Re-charge battery and contact your dealer for
technical support if the error happens again.
Inter CKT Fault
Over Current occurs during
battery charging or discharging.
Restart the inverter and contact your dealer
for technical support if the error happens
again.
BUS Voltage is too high or
internal failed
Inter Com Fault
Internal communication failure
(ARM&DSP).
EEPROM Fault
Internal EEPROM Component
(ARM) damaged.
BMS Fault
BMS communication failure.