Risk of burns due to electric arcs
• Short-circuit currents in the battery can cause heat build-up and electric arcs.
• Disconnect the battery from all voltages sources prior to performing any work on the
battery.
• Observe safety information of the battery manufacturer when working on the battery
or inverter.
• Improper settings or maintenance can permanently damage the battery.
• Incorrect inverter parameters will lead to the premature aging of battery.
2.4 Installation Safety
•
As soon as receiving the inverter please check if it is damaged during its
transportation. If yes, please contact your dealer immediately.
• Adequate ventilation must be provided for inverter installation location.
• Mount the inverter in vertical direction, and ensure that no objects block the heat
dissipation.
• The safety instructions in this manual cannot cover all the precautions that should
be followed. Perform operations considering actual onsite conditions.
• LIVOLTEK shall not be held liable for any damage caused by violation of the safety
instructions in this manual.
2.5 Electrical Safety
• Before installing the inverter check all electrical ports to ensure no damage and no
short circuit, otherwise personal casualty and or fire will occur.
• Input terminals of the PV inverter apply only to input terminals of PV String do not
connect any other DC source to the input terminals.
• Before connecting PV Arrays ensure that is its voltage is within the safe range.
• Before touching the DC cables, operator must use a measuring device to ensure that
the cable is voltage-free.
• The operator must follow all warnings on the PV strings and in its manual.
To Next Page
Loading...
