Electronic Control "LCM" Mode d'emploi
firmware 0.06 Vers.02 FR 14/ 15
8.1. Variables utilisateur :
Type de MODBUS : HOLDING REGISTER
Commande de lecture : 03 (03Hex)
Commande d'écriture : 16 (10Hex)
Changement mode :
0 = Cool; 1 = Heat; 2 = Auto
Etat On Off (Memorized into
EEprom)
0 = Off; 1 = On
Contrôle ventilateur
0 = Min; 1 = Med; 2 = Max; 3 =
Auto
Valeur de consigne Chaleur
Profil 1 : Consigne Bande Froid 1
Profil 1 : Consigne Bande Froid 2
Profil 1 : Consigne Bande
Chaleur 1
Profil 2 : Consigne Bande Froid
Profil 1 : Consigne Bande
Chaleur 2
Profil 1 : Consigne Bande Chaleur 1
Profil 2 : Consigne Bande
Chaleur
Profil 1 : Consigne Bande Chaleur 2
Profil 1 : Consigne Bande Froid 1
Profil 2 : Consigne Bande Chaleur
Profil 1 : Consigne Bande Froid 2
Profil 2 : Consigne Bande Froid
Sélection Profil Lundi
1 = P1; 2 = P2; 3 = P3; 4 = P4
Sélection Profil Mardi
1 = P1; 2 = P2; 3 = P3; 4 = P4
Sélection Profil Mercredi
1 = P1; 2 = P2; 3 = P3; 4 = P4
Sélection Profil Jeudi
1 = P1; 2 = P2; 3 = P3; 4 = P4
Sélection Profil Vendredi
1 = P1; 2 = P2; 3 = P3; 4 = P4
Sélection Profil Samedi
1 = P1; 2 = P2; 3 = P3; 4 = P4
Sélection Profil Dimanche
1 = P1; 2 = P2; 3 = P3; 4 = P4
Activation Profil
0 = Off; 1 = On
Point de consigne CO2 avec
ventilateur
Valeur de consigne pression
ventilateur alimentation
Pressure Full Scale Sensor
Valeur de consigne pression
ventilateur échappement
Pressure Full Scale Sensor
Gestion ventilateur échappement
Activation fonction Night à partir
terminal
Night : Consigne vitesse ventilateur
Night : [%]
Night : Valeur de consigne Froid
Night : Valeur de consigne Chaleur
Dégivrage : Valeur de consigne
temp. expulsion
Différentiel changement mode