SAFETY DEVICES - The plasma unit used on the Vulcan have safety interlocks to prevent danger
to personnel and damage to machine.
Never attempt to short out or override these interlocks! Check
the interlocks and all safety related parts of the plasma unit frequently and replace them
IMMEDIATELY
if they are not working!
The interlocks disconnect the power supply when the retaining cap is loosened.
Never bypass or shortcut the safety interlocks on any of the plasma system units.
Do not use the plasma unit unless all of its power supply covers are in place; failure to do so will
ENDANGER the operator and bystanders near the machine and will interfere with the cooling of the
vital parts of unit, which may be damaged as a result.
Be certain that all electrical connections are covered with appropriate insulation material. Cracked
insulation must be replaced!
Each plasma unit is designed to be used only with specific Vulcan torches. Do not substitute other
torches which may overheat and present a potentially dangerous situation to the operator and any
personnel in the area.
Safety... Page 6
H. WEISS MACHINERY & SUPPLY
H. WEISS MACHINERY & SUPPLY
PHONE: (718) 605-0395 - www.hweiss.com
To Next Page
