SECTION 4.722
If you have not yet connected your device to Lockly App, follow below steps to activate the rain
mode feature:
RAIN MODE ON
1. Long press to enter fixed digit keypad.
2.
Enter
access code +234+ .
3. You will hear a short beep and Bluetooth
indicator flashes green once Rain Mode is ON.
RAIN MODE OFF
1. Long press to enter fixed digit keypad.
2. Enter access code +890+ .
3. You will hear a long beep and Bluetooth
indicator flashes green once Rain Mode is OFF.
example: 135790 + 234 +
example: 135790 + 890 +
Like other digital electronic products water can trigger to activate the touchscreen and fingerprint
sensor which may cause the batteries to drain. To protect the lock and extend battery life, you can
setup your Lockly to enter Rain Mode to shut off keypad and fingerprint reader whenever rain or
water is detected.
Activate this feature on the Lockly app. While you are within the Bluetooth range or remotely con-
nected thru Wi-Fi hub, go to Settings > Rain Mode and toggle the button to turn ON.
4.7 Rain Mode
To reactivate fingerprint and keypad access when
your lock has
entered rain mode, turn the key cover.
When RAIN MODE is ON, the keypad and fingerprint
sensor
cannot be used. Unlock via Lockly App,
physical key, or
voice with your Amazon Alexa or
Google Assistant-enabled
devices. Rain Mode auto exits every 30-mins and re-enters if water
or rain is still present.
If you are using the Lockly app, you will be notified when Lockly
entered rain mode it will be recorded in your access history.
IMPORTANT
To Next Page
Loading...
Need help?
General
