73 -
english
Setting the pre-record and post-record time
For timer recordings, a lead and follow-up time can be set. This minimises
the risk of a part of the broadcast not being recorded due to the broadcast
starting earlier and/or finishing later.
MENU:
Call TV menu.
Choose Recording,
switch to the menu line below.
Set pre-record or post-record time,
switch to the menu line below.
Enter the time using the numeric buttons (always 2-digit:
01 to 15 mins for pre-record time; 01 to 60 mins for
post-record time). Factory setting: pre-record: 00 min,
post-record: 00 min.
Archive recording – Direct recording
➠ For recording encrypted broadcasts, please also refer to the informa-
tion on pages 83 and 84.
Press RECORD button briefly: Start direct recording.
The Recording duration selection is called.
Select desired recording time.
current programme: The broadcast being watched is
adopted in the archive.
??? : Manually enter the recording dura-
tion with the numeric buttons of the
remote control.
OK Confirm. Call Timer data.
Check the timer data, change if necessary and confirm
with OK. The recording is started.
See page 76 for explanations of the setting options in the Timer data
menu.
Post-record time Recording wizardlist
PRE-RECORD TIME
If you record a programme without VPS, you can enter a time span here
specifying how long before the scheduled time your programmed recording
should start so that programmes which begin too early are recorded
in full.
TV MENU
Recording
Pre-record time
00 min (0 - 15)
Digital Recorder
OK
OK
30 60 90 120 180 240 ???
RECORDING DURATION (MIN.)
current programme
confirm
OK
09
-
OK
TIMER DATA
09:45 Bon(n) jour Berlin
Parental lock
confirm
Recorder USB
Station 45 Phoenix
Date 05.02.2010
Recording time 09:45 until 10:00
Recording type once only
To Next Page
Loading...
Need help?
General