93 -
english
Connecting digital audio amplifiers
Continuation of the left column above ...
For digital audio transmission: Select yes.
Connect the digital audio output of the TV set AUDIO DIGITAL OUT with
the digital audio input of the amplifier via a cinch cable:
Connecting analogue audio amplifiers
Continuation of the left column above ...
For digital audio transmission: Select no.
Use a stereo cinch cable to connect the analogue audio output AUDIO
OUT L/R with the analogue audio input of the amplifier:
R
L
AUX IN
R
L
DIGITAL IN
Connecting HiFi/AV amplifiers
The sound components wizard permits configuration of different audio
amplifiers (stereo amplifiers, surround amplifiers, analogue or digital) with
different digital audio formats (Dolby Digital, dts, MPEG, and stereo/PCM).
See the operating manual of the audio amplifier for more information.
MENU: Call TV menu.
Select Connections,
go to the menu line below.
Select Sound components.
OK calls the sound components wizard
Mark HiFi/AV amplifier or HiFi/AV amplifier or TV
speakers (switchable).
OK Proceed.
Select whether the sound is to be transmitted digi-
tally or analogue to the the amplifier. Continue,
depending on the amplifier, see right column.
Explanations of the setting possibilities:
Select this setting if an amplifier is connected and you do
not wish to use the TV loudspeakers any more.
Sound reproduction optionally via an external audio
amplifier or via the built-in TV loudspeakers. The playback
can be toggled between TV speakers and external audio
amplifier in the Sound menu under Sound via.
Specify sound formats which can be decoded with the digital
amplifier (see operating manual of the used amplifier).
External devices
AUDIO OUT
DIGITAL
TV set
Digital amplifier
Analogue amplifier
TV set
AUDIO OUT
L/R
HiFi/AV
amplifier
HiFi/AV
amplifier or TV
speakers
(switchable)
Sound formats
OK
OK
SOUND COMPONENTS
Sound playback via ...
TV speakers
Speaker system
HiFi/AV amplifier ۪
HiFi/AV amplifier or TV speakers (switchable)
End of wizard