LOGICDATA SMARTneo Series User Manual

USER MANUAL SMARTneo // PAGE 24
10 SOFTWARE-DEPENDENT
FUNCTIONS
The motor control unit SMARTneo is parameterised with software before delivery. The following functions
can be used only when the motor control unit is parameterised appropriately.
10.1 SLOW TRAVEL SPEED AREAS
This function (low speed area) causes the speed to be slowed automatically during the table top adjustment
before the following positions are reached:
• Highest and lowest table top position
• All saved positions (e.g.: memory positions, container stop position)
10.2 SAFETY AREA
This function causes a safety stop at a dened table top position (congured with software). The safety stop
functions as follows:
Press the button Table top down (and continue to press it).
The table top is adjusted to the start of the safety area.
The table top adjustment is stopped above the safety area.
Press the button Table top down again. The table top is then
adjusted to the lowest table top position.
NOTICE
Saving the table top positions is not possible in safety areas.

LOGICDATA SMARTneo Series Specifications

General

Brand	LOGICDATA
Model	SMARTneo Series
Category	Controller
Language	English