USER MANUAL SMARTneo // PAGE 36
13.2 ERROR MESSAGES ON THE DISPLAY
OF THE HAND CONTROL
Problem Cause Remedy
HOT
The display shows
HOT.
The motor control unit SMART-
neo is equipped with overheating
protection. This overheating
protection at activated because of
overheating.
Wait until the motor control unit
has cooled o and the message
HOT on the display goes out. The
motor control unit SMARTneo is
then operational again.
Eoo
The display shows E
and an error number.
There is an internal motor cont-
rol unit SMARTneo error.
Proceed according to the follo-
wing error list.
To Next Page
Loading...
