USER MANUAL SMARTneo // PAGE 30
10.9 CHANGING THE NUMBER OF MOTORS
NOTICE
The factory settings are 2 motors for the SMARTneo.
Only skilled technical sta
This function must be carried out only by skilled technical sta.
An incorrect number of motors can lead to damage to the table.
NOTICE
A hand control with display and memory buttons is required for
this procedure.
In order to change the settings, you must proceed as follows:
1
2
Simultaneously press the memory position buttons 1, 2 and the button Table top up.
Hold the button combination for approx. 3 seconds. Then release the buttons.
S 5
The display shows S and a number, e.g. S 5.
Press the button Table top up until the display shows S 8.
S 8
The display shows S 8..
SAVE
Press the memory button.
The display now shows the currently set number of motors (1 or 2)
or
Press the button Table top down in order to reduce the number of motors. The lowest
possible number is 1.
Press the button Table top up in order to increase the number of motors. The highest
possible number is 2.
The display now shows the selected number of motors.
SAVE
Press the memory button to conrm the setting.
To Next Page
Loading...
Need help?
General
